Download Print this page

Whirlpool ADG 9190 Quick Reference Manual

Dishwasher

Advertisement

Further indications are given in the single chapters and in the user instructions.
Open the door,
switch on the appliance
Select, save, and
supply the detergent
Check the rinse aid level
Check the
regeneration salt level
Load the racks
Select a programme
Select additional options
Press the Start button
Turn on the water tap,
close the dishwasher door
Switch off the appliance
Turn off the water tap,
unload the racks
How to use the appliance
Press the ON button.
(The first time you use the appliance
and when using a different type of
detergent)
1. Select the third programme from the
top in the relative table.
2. Press the Start button for about 7
seconds until the display changes.
3. Select the required detergent with the
Start button: "3h" = 2in1, "6h" = 3in1, "9h" = All in 1, all three LEDs
on = soap powder (factory setting).
4. Switch the appliance off and then switch it on again. The type of detergent
selected is shown by the relative LED for approximately three seconds.
For dosage of powder detergent in compartment A and B refer to the
programmes table.
Mechanical indicator C.
Electric indicator on control panel (if provided).
On models with water softener
system only.
Mechanical indicator D. Electric
indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Press P or
until the selected programme lights up.
If necessary the corresponding indicator lights up.
The selected programme is
then memorised (even in the
event of power failure).
At the end of the programme an acoustic signal will sound.
Only after the START button has switched off: press the OFF button.
All the indicator lamps switch off.
Warning: When the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
A
"Change programme in progress"
Press the START button for 2 sec. until the
Start indicator lamp switches off.
Select another programme and press the
START button again.
- Only open the dishwasher if necessary
(Warning: beware of hot steam).
- If the appliance is switched off during a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.
B C

Advertisement

loading

Summary of Contents for Whirlpool ADG 9190

  • Page 1 How to use the appliance Further indications are given in the single chapters and in the user instructions. Open the door, Press the ON button. switch on the appliance (The first time you use the appliance and when using a different type of detergent) 1.
  • Page 2: Lower Rack

    Dishwasher loading instructions and racks provided Upper rack: depending on the model Multi-purpose support (A): Depending on the position, for long- handles utensils, cups and glasses. May be used in three different positions. Crockery holders (B): Depending on the position, for example plates, cups and long-stemmed glasses.
  • Page 3: What To Do If

    What to do if... If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem Cause Remedy The appliance is not •...
  • Page 4: Programme Chart

    Important information for Test Laboratories: For detailed information on the EN/Standard loading comparison test, contact the following address: “nk_customer@whirlpool.com”. 5019 396 01682 Whirlpool is a registered trademark of Whirlpool USA...