Appendix 2: Enabling Wep In The Axis Officebasic Usb Wireless - Axis OfficeBasic USB Wireless User Manual

Appendix 2: Enabling WEP in the AXIS
AXIS OfficeBasic USB Wireless

Appendix 2: Enabling WEP in the AXIS OfficeBasic USB Wireless

OfficeBasic USB Wireless
If your WLAN is Infrastructure-based (with an Access Point) and uses WEP
encryption, follow these instructions to connect and install the AXIS
OfficeBasic USB Wireless print server:
1. Switch the print server's DIP switch to DIAG mode.
2. Create a new profile or use an existing one on your laptop to connect to the
print server, as described in Appendix 1: Print Server Setup in Ad Hoc Mode,
on page 43.
3. Install and run AXIS OBW Wizard.
4. From the Select A Print Server screen, select your print server and click Next.
5. On the Change Settings screen select Yes and click Next.
6. On the Basic Wireless Settings screen keep Infrastructure (default) as
communication type.
7. Keep <ANY> as default SSID or change it to match your WLAN settings.
8. Keep Auto as default Data transmit rate or change it to match your WLAN
settings. Click Next.
9. On Security and WEP Encryption Settings screen, check Enable WEP
Encryption.
10. Choose Type (64-bit or 128-bit), Key Format (Alphanumeric or Hexadecimal)
and enter an Encryption Key to match your WLAN settings. Click Next.
11. Click Next on the 802.1X Settings screen if you do not use any kind of
authentication. If MD5 is selected, you must enter the same Login Name and
Password as defined on the Radius server.
Note: A Radius server is used for remote user authentication and accounting.
Its primary use is for Internet Service Providers, though it may
as well be used on any network that needs a centralized authentication and/or
accounting service for its workstations.
12. In TCP/IP Settings, specify a fixed or dynamic IP address, then click Next. A
fixed IP address is highly recommended; select Specify an IP address and fill
the settings to match your WLAN settings. Click Next.
13. Click Next again to save your settings.
14. Click Cancel on the Select A Printer screen (as you are not going to install
a printer).
15. Switch the print server's DIP switch back to NORMAL.
16. From a workstation on your LAN, open a Web browser, enter the IP address
of your print server to verify the AP connection in the WEP encrypted WLAN
and press Enter. The print server's internal web pages will appear.
For detailed information about WEP settings, see Setup Menu, on page 33.
45