Summary of Contents for Charles 5000 SP C-CHARGER Series
Page 1
LT-5000SP-1 Issue 1 Print 6 C-CHARGER INSTALLATION INSTRUCTIONS & OWNER’S MANUAL MARINE ELECTRONIC BATTERY CHARGER 5000 SP Series E Charles Industries, Ltd. All rights reserved. Printed in the United States of America.
100-135V 13 15 1/4 x 9 5/8 3 3/4 15A/250V* 40A/32V** Figure 3 93-24405SP-A 100-135V 16 15 1/4 x 9 5/8 3 3/4 20A/250V* (2)30A/32V** Figure 3 E Charles Industries, Ltd. All rights reserved. Printed in the United States of America.
Charger, Troubleshooting the SP Series C-Charger and Warranty & Customer Service. Maintenance/Cleaning Precaution To reduce risk of electrical shock, disconnect the SP series C-Charger from AC power and batteries before at- tempting any maintenance or cleaning. E Charles Industries, Ltd. All rights reserved. Printed in the United States of America.
The 5000 SP series C-Chargers have been specifically designed for hard-wired marine use inside a boat. They are not designed or equipped for charging batteries on shore or outside a boat. E Charles Industries, Ltd. All rights reserved. Printed in the United States of America.
If using Odyssey batteries, the switch should be set for LEAD ACID. LEAD ACID BATTERY − GEL BATTERY − AGM BATTERY − Figure 1. Battery Type Selectable Switch (Bottom View) E Charles Industries, Ltd. All rights reserved. Printed in the United States of America.
Use Table 2 to determine the appropriate wire gauges. Avoid unnecessarily long runs of either AC or DC power lines. DANGER Before working on electrical equipment, first determine there is no live power! Double check power connections and all battery terminations. E Charles Industries, Ltd. All rights reserved. Printed in the United States of America.
Page 8
18 AWG 16 AWG 14 AWG 8 inch-pounds 12 AWG 12 AWG 16 inch-pounds 9C-24305SPI-A 16 AWG 14 AWG 12 AWG 8 inch-pounds 10 AWG 10 AWG 16 inch-pounds E Charles Industries, Ltd. All rights reserved. Printed in the United States of America.
In accordance with ABYC E-11, a fuse or circuit breaker must be placed within 72 inches of the point of connection to the batteries or its bus on all positive output conductors. Also see Coast Guard Reg. 33CFR183 subpart I. E Charles Industries, Ltd. All rights reserved. Printed in the United States of America.
Page 10
150% of the rating of the conductor. 4. Black jumper (common negative) - only necessary if batteries are not pre-wired with common negative. E Charles Industries, Ltd. All rights reserved. Printed in the United States of America.
If the SP series C-Charger does not charge batteries or perform as described, refer to the section in this manual on Troubleshooting the SP Series C-Charger. E Charles Industries, Ltd. All rights reserved. Printed in the United States of America.
Table 4. If the problem is not covered in Table 4, or if the SP series C-Char- ger still malfunctions after performing the solution given, contact Charles Marine Products for technical assis- tance. E Charles Industries, Ltd. All rights reserved. Printed in the United States of America.
217−932−2317 (Voice) 217−932−2473 (FAX) Call to obtain a Returned Materials Authorization (RMA) number prior to returning any unit to Charles Industries. Return the unit for repairs to the Service & Repair Center address below: E Charles Industries, Ltd. All rights reserved. Printed in the United States of America.
5600 Apollo Drive Rolling Meadows, IL 60008-4049 847−806−6300 www.charlesindustries.com SPECIFICATIONS The specifications for the 5000 SP series C-Charger are listed in Table 1. g g g E Charles Industries, Ltd. All rights reserved. Printed in the United States of America.
Need help?
Do you have a question about the 5000 SP C-CHARGER Series and is the answer not in the manual?
Questions and answers