Electrical Specifications - Cello PERFORMANCE AMPLIFIER II Owner's Manual

PERFORMANCE AMPLIFIER
10

Electrical Specifications

Power Output
Single Amp Rated
Load (Ohms) Watts (RMS)
8
4
2
1 1000
Bridged Set
Load (Ohms) Watts (RMS)
8
4 1600
2 3200
* NOTE: Clipping levels obtained with 1kHz continuous sine wave. It may be
necessary to alter the AC line in order to provide the current needed to reach
these levels for testing. This does not become a major issue when playing
music, even at continued high volume levels into low impedance loads.
IMD SMPTE
60Hz & 7kHz
40V output ..................................................................................... 08%
THD
20Hz - 20kHz
8 & 4 Ohms, 40V output .......................................................... <0.1%
1 Ohm, 33V output .....................................................................<.3%
Frequency Response
20kHz ......................................................................................... -0.8dB
40kHz ......................................................................................... -3.0dB
Channel Separation
L - R ...........................................................................................Infinite
Signal to noise
40V output
20Hz - 20kHz ...........................................................................<-105dB
Input Impedance
Non-inverting ........................................................................ 1MOhm
Inverting ................................................................................ 5kOhms
Input Sensitivity
40V output, 8 Ohms
200W(RMS) ............................................................................... 1.485V
Gain ..................................................................................................... 28dB
NOTE: All measurements are for one supply, one amp.
(All specifications subject to change without notice)
* Clipping @ 1kHz
Watts (RMS)
200 > 350
400 > 700
800 >1000
>1300
Watts (RMS)
800 >1400
>2800
>4000