LG F1*20TD(1~9) Series Service Manual page 11

8
Check the horizontality with a level (Gage).
1 Step
If washing machine legs are loose or not screwed, then
Using the level, level the washing machine from front to back and side to side.
A level
2 Step
Using the spanner wrench to adjust leg for
Diagonal test
Higher
Tighten
Adjustable feet
Lower the foot until there is no gap between floor and foot.
And only use adjustment rubber
Rubber Cup
3 Step
Perform a Rinse and Spin with some clothing in the machine.
To do this, put 2~3kg of clothing in the unit, power on the unit, press the Rinse and Spin
button, and then start. When the unit reaches the spin cycle, watch for vibrations.
If the unit is vibrating, make small adjustments to the leg until they subside. (Try 2Step again)
4 Step
Tighten the lock nut against the base of the machine to
How to perform a diagonal test:
Place your right hand on the back, right corner and your left hand on the front,
left corner of the unit, then attempt to rock the unit from corner to corner.
Then, move your right hand to the front, right side and your left hand to the
back, left corner and attempt to rock the unit from corner to corner.
If the unit is level, it will not rock. However, if the unit is not level, it will rock.
If the unit rocks, it will be necessary to adjust the leveling feet of the unit.
Adjust the foot under the hand that is on the front of the machine.
Lower
Tighten
Adjustable feet
when difference at the leg adjustment is more than 10mm.
screw up
Tighten
Adjustable feet
horizontality and try for
Lock nut
Adjustable bolt
4620ER3001A
(Black)
for Tile floors
lock the
10
with the spanner wrench.
Higher
Diagonal test.
4620ER3001B
(Gray)
for Wooden floors
position leg.
Tighen the lock nut
10mm