Intermec ScanPlus 1802 Operator's Manual

Battery charger

Hide thumbs Also See for ScanPlus 1802:

Download this manual

Operator's Guide

ScanPlus 1802

Battery Charger

Table of Contents

Page 1 Operator's Guide ScanPlus 1802 Battery Charger...
Page 3: Installation
Installation ➊ ➋...
Page 4: Operation
Operation   Power on Insert battery or scanner  Initial battery state (during 10 seconds) high medium The initial state of the battery is displayed for 10 seconds before charging starts. This indication is only valid if the battery is left idle (not charged or discharged) before you place it in the battery charger.
Page 5   Battery fully charged Charging Full charging takes up to hours.
Page 6: Troubleshooting
Do not store a battery/scanner for an extended period of time in a charger which is not powered up, because the battery will discharge faster. Only use the charger for Intermec Ni-Mh Hybride Battery packs rated .V, 00mA, 0. Ah (P/N - 009-1).
Page 7: Regulatory Statements
The information contained in this document is for informational purposes only and is subject to change without notice. No part of this document may be copied or reproduced in any manner without the prior written permission of Intermec Technologies Corporation.
Page 8 U.S. service and technical support, tel: 1 800 0 • Canadian service and technical support, tel: 1 800 88 0 Europe / Middle East / Africa • Sovereign House, Vastern Road, Reading RG1 8BT, England Tel: + 118 98 900 • Fax: + 118 98 901 Internet: www.intermec.com E-mail: info@intermec.com P/N -009-0...