Fujitsu Primergy RX300 S2 Start Manual page 2

4
Checking location before installing the server
For details on installing the rack, refer to the "Installation
Guide for the RACK" and the manual provided with the
rack.
nConditions
When installing this server avoid the following areas.
- Humid, dusty, or oily areas
- Poorly ventilated areas
- Areas close to fire or other sources of heat
- Areas close to water
- Areas close to direct sunlight or near heating appli
ances
- Areas with a temperature of below 10°C or above 35°C
- Areas with humidity of less than 20% or more than 80%
- Salty areas
- Areas where corrosive gas is generated
- Areas where cables become trip hazards
- Areas where strong magnetic fields are generated,
such as near TVs and speakers
- Areas where the device is not stable and could tip
over and hurt somebody
- In dusty area, dust will quickly stick to the front and
backside of the server. Since this can cause failure,
changing the installation place is recommended.
- Be sure to secure racks and cannect stabilizers to prevent
the device tipping over.
nInstalling the server to the rack
Make sure to contact an office listed in the "Contact In-
formation" before attempting to install or remove a server
from the rack.
1
Open both the front and rear doors of
the rack.
2
Check where to attach the slide rail
and rack nuts
Attach the slide rail to the front and rear brackets.
Attach the rack nuts to the front brackets.
���������������������������
���������������
�������������
������������������������������
������������������������������
��������������������������
������������������������������
������������������������������
��������������������� �
3
Remove the inner rail from the slide
rail
Press down the lock in the center of the inner rail
to remove.
�������������������
����������
4
Attach the inner rail to the server.
���������������������������
����������������������
���������������
Left and right inner rails are different.
Check the letter at the lock part for correct installation.
5
Remove the flathead screws fixing the
slide rail bracket, and attach binding
head screws.
Two on the front: Tightly fasten where the flathead
Two on the rear: Loosely fasten at the location in
��������������������
����������������������
�������
����������������������������������
�����������������������������
���������������������������������
2
����������
����������������
�
����
���������������������������
screws were used.
the following figure.
����������������������
���������������
������