HoMedics SC-630 Instruction Manual page 3

SC-630-A.qxd 10/6/06 3:49 PM
3. Use SCREW DRIVER to hook POTHOOK into the hole of LONG ARM
CONNECTION PLATE
4. Use ALLEN KEY to remove the pre-set ASSEMBLY SCREW (located on
the bottom of the base) to release LONG ARM CONNECTION PLATE
into place
Assembly
Screw
5. Use SCREW DRIVER to attach POLE to BASE by inserting and turning the
2 screws tightly
6. Slide POLE COVER down
Page 5
Pothook
Long Arm
Connection
Plate
Screws
5
Setting The Zero Point and Balance
Before using the scale for the first time or when the scale has been moved to
another place, you must set the zero point and balance the scale before
weighing yourself.
Zero Point
1. With nothing on the PLATFORM, adjust POINTER to ZERO using
ADJUSTING KNOB found under DIAL, on the unit's back side.
Balance
1. Place the scale on a flat, firm surface
2. Turn 6 LEVELING FEET until the bubble inside LEVEL is directly in the
middle of the circle
Level
Platform Top
Leveling Feet
6
Adjusting
Knob
Locking
Dial
Leveling
Foot