Advertisement
D.I. Section:
D.I. Nominal Output Level: -20dBu
D.I. Pre/Post Button:
Pre - Your signal goes to the D.I. XLR output jack before your Gain and EQ
settings, but after the –10dB input pad.
Post - Gain , EQ, Master settings and effects will be sent to the D.I. XLR
output jack.
Lift/Ground: If there is a hum when using the D.I. there may be a ground
loop. In many cases pushing in the Lift/Ground button can fix this
problem.
* Note: The Tone Hammer 500 will not be harmed by phantom power
through the D.I. Phantom power is a power supply that can be switched
on at the channel input of some mixing consoles and is used to power
some types of microphones. Use of phantom power (usually labeled as
48V) will have no effect on the D.I. or the amplifier in general.
B. Rear Panel Features
Speaker Outputs:
Two speakon outputs are provided. Any combination may be used as long
as the load does not go below 4 ohms. The speakon jacks are wired +1,
-1
Tuner Output:
One ¼" Tuner output is provided. When the amplifier is muted your signal
will still reach the tuner.
Input Voltage Selector:
The Input Voltage switch allows you to change the operating voltage if
you travel with your Tone Hammer 500. You can select between 115V for
100-120V and 230V for 220, 230 or 240V.
6.
Hide quick links:
Advertisement
