Dell PowerVault MD3200i Deployment Manual page 61

6 Click OK to exit the Advanced menu and click OK again to exit the Add
Target Portals screen.
7 To exit the Discovery tab, click OK.
If you plan to configure CHAP authentication, do not perform discovery on
more than one iSCSI port at this point. Go to "Step 4: Configure Host
Access" on page 62.
If you do not plan to configure CHAP authentication, repeat step 1 thorough
step 6 for all iSCSI ports on the storage array.
If you are using Windows Server 2008 Core Version:
1 Set the iSCSI initiator service to start automatically:
sc \\<server_name>
2 Start the iSCSI service: sc start msiscsi
3 Add a target portal:
iscsicli QAddTargetPortal
<IP_address_of_iSCSI_port_on_storage array>
If you are using Red Hat Enterprise Linux 5, Red Hat Enterprise Linux 6,
SUSE Linux Enterprise Server 10, or SUSE Linux Enterprise Server 11:
Configuration of the iSCSI initiator for Red Hat Enterprise Linux 5 and
SUSE Linux Enterprise Server 10 SP1 distributions is done by modifying the
/etc/iscsi/iscsid.conf file, which is installed by default when you install
MDSM. You can edit the file directly, or replace the default file with a sample
file included on the PowerVault MD series resource media.
To use the sample file included on the media:
1 Save the default /etc/iscsi/iscsid.conf file by naming it to another name of
your choice.
2 Copy the appropriate sample file from /linux/etc on the media to
/etc/iscsi/iscsid.conf.
3 Rename the sample file to iscsid.conf.
4 Edit the following entries in the /etc/iscsi/iscsid.conf file:
Edit or verify that the node.startup = manual line is disabled.
a
Edit or verify that the node.startup = automatic line is
b
enabled. This enables automatic startup of the service at boot time.
config
Appendix—Manual Configuration of iSCSI
msiscsi start= auto
61