Disassembly Process; Equipment Needed & Product Overview - Optoma EP776 Service Manual

Chapter 2
Disassembly & Assembly Process
2-1 Equipment Needed & Product Overview
1. Screw Bit (+) :107
2. Hex Sleeves 5mm
3. Screw Bit (+) :102
4. Hex Sleeves 7mm
5. EP776W unit
* Before you start: This process is protective level II. Operators should wear electrostatic chains.
* Note: If you need to replace the main board, you have to get into service mode and record the
lamp usage hour. please refer to section 2-30.
Note:EP776 Series&EP782 Series are the same,here we take EP776W as an example.
EP776 Series/EP782 Series Confidential
2-