Network - Philips 49PFL4909 User Manual

Network

Set up Network connection settings in order to use Net TV or Network
Upgrade function.
The meanings of abbreviations are defined as below.
●
AP
: Wireless LAN Access Point
WPS
: Wi-Fi protected Setup
SSID
: Wireless network name
The key entry screen will appear when you select SSID, WEP /
●
WPA / WPA2 or Proxy address.
―
1 2 3 4 5
a b c d e
k l m n o
u v w x y
Clear All clear
Enter the key of the selected wireless network using H I J K,
●
then press OK.
Clear
: Clear the entered number or word.
All clear
: Clear all the entered numbers or words.
a/A/@
: Switch between abc, ABC and @!?
Cancel
: Shows the cancellation display.
OK
: Set the entered number or word.
1
Use H I to select Network, then press OK.
Language
Settings assistant
Channels
Picture
Preferences
Sound
Network
Features
Restore default settings
Installation
Software
6 7 8 9 0
f g h i j
p q r s t
z . - _
a/A/@ Cancel OK
English
Autoprogram
Location
Network settings a
Reset AV settings
Network settings assistant
Before you proceed to Connection test or other settings in Network
section, run the Network settings assistant to connect the TV to your
Network.
2
Use H I to select Network settings assistant then press OK.
Network settings assistant
Language
Manual network settings
Channels
Connection test
Preferences
Setting status
Network
Home network
Restore default settings
Reset network settings
3
Press OK to select Start now.
Wireless setting
Select to use a wireless LAN to connect to the internet by wireless
connection.
4
Use H I to select Wireless, then press OK.
This TV can be connected to your
home network.
Select your connection type.
If not connected to the network,
the latest TV software can be
downloaded from
www.philips.com/support
Cancel
5
Use H I to select the desired setting, then press OK, and follow
the On-screen Instructions.
Select this setting if your router has a Wi-Fi
Protected Setup (WPS) button. Start scanning
for wireless networks on the TV after pressing
Easy Connect
the WPS button on your router. If connection
test fails, try Easy Connect again.
refer to the router's manual for more details.
Search for Wireless Networks automatically and
Scan select the Wireless Network name (SSID) from
the list. Wireless network setting L p. 40
Set up the connection to the Wireless LAN
Manual
Access Point (AP) (e.g. wireless router) manually
by entering the Wireless Network name (SSID).
* WPS (Easy Connect) cannot be used when the security protocol is set
to WEP. Change the Access Point's security mode from WEP to WPA
or WPA2 (recommended).
Wired setting
Select to use an Ethernet cable to connect to the internet by wired
connection. Please purchase shielded Ethernet cables at your local store
and use it when you connect to Network equipment.
4
Use H I to select Wired, then press OK.
Connection test will start automatically. L p. 42
●
39 .
English
Start now
Network selection
Start now
Information
Renderer
Start now
Wireless
Wired
If it fails then
*
Continued on next page.