VALERA CONIX 641.02 Instructions For Use Manual page 3

•Do not put the appliance on heat sensitive surfaces during use.
•After use always switch the unit off and remove the plug from the power supply socket. Do not pull
on the wire to remove the plug from the power supply socket. Do not pull the plug out of the power
supply socket when your hands are wet.
•Always allow the unit to cool before putting it away and never wrap the cord around the unit.
•Check that the cord has not been damaged from time to time.
•Prevent the cord from coming into contact with the metal parts while these are still hot.
•Use the unit on dry hair.
•Do not use this unit on wigs that have synthetic hair.
•The elements used to pack the unit (plastic bags, cardboard box, etc.) must be kept out of reach of
children as they are a potential danger to them.
•This unit must only be used for the purposes for which it is expressly intended. Any other use is to
be considered improper and therefore dangerous. The manufacturer accepts no responsibility for
damage caused by improper or erroneous use.
•Do not use hair spray while the unit is running.
•Keep the plates clean and free of dust, hair spray, styling gel, etc.
•To avoid dangerous overheating, it is advisable to unwind the entire length of the cord.
1 Appliance
2 0/1 switch
3 On/Off led indicator
4 Conical curling tong
To switch the appliance on, simply plug it into an electrical socket and move the switch (fig. 1,
ref. 2) to I. To switch it off, move the switch (fig.1, ref. 2) to 0 and remove the plug from the socket.
This appliance is designed to create curls and ringlets of various sizes.
Let the appliance preheat for about 2 minutes before using.
• Hair that has just been washed and dried can be styled better.
• The first few times you use this unit it is advisable to practice on small areas of your hair.
• The effect obtained depends on how thick and how long your hair is as well as curling time. Start
by using a curling time of 10-20 seconds.
• If necessary, repeat the various steps until you achieve the required effect.
• To obtain ringlets and curls of various sizes, comb and separate the hair into sections about 2 cm
wide. Wind a lock of hair at a time on the tong starting from the hairline down to the tips
(fig. from 2 to 4).
hair on the iron, and the longer the curling time, the tighter the resulting curls will be. At the end of
the curling time, carefully remove your hair from the iron (fig. 5). To increase the duration of the
curl, wind it around one of your fingers while waiting for it to cool.
• Let your hair cool completely before combing or brushing it.
Always remove the plug from the power socket before beginning to clean the unit!
Leave the unit and any accessories used to cool down before cleaning.
This unit can be cleaned using a damp cloth, but it must never be immersed in water or any other
liquid!
This appliance conforms to European Directives 2004/108/EC, 2009/125/EC, 2006/95/EC
and Regulation (EC) No. 1275/2008.
5 Cold end
6 Finger protection
7 Thermal pouch
5
The greater the force you apply to wind your