Download Print this page

Important Suggestions; Fuse Replacement; Care And Maintenance; Troubleshooting - Rubbermaid Thermo-Electric Travel Cooler and Warmer Owner's Manual & Warranty Information

Advertisement

For extended use:
Plug the Rubbermaid Thermo-Electric Travel Cooler & Warmer into
vehicle's12 volt DC accessory outlet to keep food and drinks cold or warm. No
more digging around in melting ice and water for soggy foods and dripping drinks.
No need for ice, dry ice, or cold/hot packs. Ideal for use in a:
• Car
• Truck or SUV
• RV, mobile home, camper
• Boat
• Home or motel – use with the VEC004ARB AC/DC Converter.
• At the beach, on picnics, at the campground – use with battery power.
Completely portable:
Take the Rubbermaid Thermo-Electric Travel Cooler & Warmer with you,
wherever you go, to keep cold or hot food and drinks at just the right temperature.

IMPORTANT SUGGESTIONS

Rubbermaid Thermo-Electric Travel Cooler & Warmer cools like a
refrigerator and warms like an oven. For best performance, plug in the unit
approximately 2 hours before loading to give it time to warm up or cool down.
Always try to fill your unit with pre-chilled or preheated food or beverages, as the
unit will always perform at its best when you do this. Generally, your unit will cool
to as much as 40°F below the surrounding temperature. To ensure optimum
performance, always keep the unit out of direct sunlight when running on the cold
cycle. When the unit is running on the warm cycle, it will warm to approximately
120°F. On cold days, the unit will need more time to reach the maximum warm
temperature. To promote your unit's cooling ability on warm days, try reusable
frozen ice packets. These are particularly helpful in keeping your unit cold while
unplugged. Contact Technical Support toll free at (800) 618-5168 for further
information.
The Rubbermaid Thermo-Electric Travel Cooler & Warmer can be used
with most food and beverages, either cold or hot. Use with standard household
containers or ready-to-use food and drink packaging. Ideal as a:
Cooler:
• Beverages – sodas, beer, wine, juice, milk, iced tea or coffee, shakes, thirst
quenchers, water and more – in cans, bottles, cartons, pouches,
sport bottles, etc.
• Food –
salads, sandwiches, deli meats, hamburgers, hot dogs, meat or
fish, buns, condiments and dips, etc.
• Desserts –
puddings, fruit cups, yogurts, etc.
• Snacks –
fruit, candy, chocolate, cookies, fruit bars, chips, etc.
Warmer:
• Beverages – hot coffee and tea, cocoa, milk, etc.
• Food –
leftovers, pre-packaged/pre-heated meals, take-out foods, soups,
covered dishes, stews, casseroles, etc.
2
Note:
When used with a rechargeable power supply, a full-charge on the power
source is recommended for optimum performance.

FUSE REPLACEMENT

The power cord is fuse-protected against short-circuiting, by a 5-amp fuse located
in the tip of the 12 volt DC plug. If the DC socket is powered, but the unit does not
operate, then the cooler/warmer fuse may be open.
To inspect or replace the DC Power Cord Fuse:
1. Unscrew the end-cap of the power cord plug.
2. Remove fuse, inspect it for an open element, and replace with a new 5-amp
fuse, if needed.
3. Re-attach the end-cap to the plug.
4. If new fuse opens, call Customer Service department at (800) 618-5168 for
further instructions and possible return/replacement. This unit is not user-
serviceable, it must be returned to manufacturer for professional service or
repair. Any attempt to service by user will void warranty.

CARE AND MAINTENANCE

The Rubbermaid Thermo-Electric Travel Cooler & Warmer is ruggedly
constructed to provide years of dependable service.
• After each use, clean the unit, inside and out, with a soft cloth and mild soap
solution.
• Do not scrape, scratch or puncture the surface of the cooler with sharp objects or
abrasives.
• Dry the unit properly and store in a cool, dry place.
• Always make sure the power cord is disconnected before storing.
• Never allow the cooler/warmer to be immersed in liquid.

TROUBLESHOOTING

Problem/Possible Cause/Remedy
• Travel Cooler/Warmer is not functioning as cooler or warmer (fan is not
turning).
Accessory outlet of DC power supply is not functioning – check by plugging
in a 12 volt DC appliance. If not, clean accessory outlet and re-connect the
Rubbermaid Thermo-Electric Travel Cooler & Warmer.
• Fuse or circuit breaker in accessory outlet is open. Reset breaker or check fuse,
and replace fuse if necessary.
• Ignition is switched off – start engine or switch ignition to "accessory" position.
• Fuse in unit's power plug is blown – see Fuse Replacement section for location of
fuse and instructions for checking and replacing fuse.
• Cooler/warmer is not cooling or heating properly (fan is not turning).
Fan is defective. Call Customer Service department (800) 618-5168 for return/
replacement instructions. This unit is not user-serviceable, it must be returned to
manufacturer for professional service or repair. Any attempt to service by user will
void warranty.
7

Hide quick links:

Advertisement

loading