Chevrolet 2013 Corvette Owner's Manual page 7

2. Press SRCE and select the
desired band (AM, FM1, FM2,
XM1, or XM2 (if equipped)).
3. Use SEEK
the desired station.
4. Press and hold one of the six
preset screen buttons, at the
bottom of the screen, until a
beep is heard or the station is
displayed on the selected preset
button.
5. Repeat the steps for each
preset.
See Preset Station Menu under
To set the time:
1. Press the power/volume knob to
turn the system on.
2. Press and hold the time display
in the upper right corner of any
screen.
3. Select the 12H or 24H screen
button to display the time in
standard or military time.
4. Press and hold the Hour and
to tune to
Min. (minute) arrow buttons to
increase or to decrease the time.
5. Select the correct time zone
screen button.
6. Select the Daylight Saving Time
screen button, if necessary.
The radio uses the GPS satellite to
set the time. The vehicle needs to
be in an open area to receive the
signal. See Clock under
.
Before entering an Address, Point of
Interest, Home, or Preset
Destination, select the correct
region that contains the final
destination. The vehicle must be
stopped to do this operation.
To set the region:
1. If the radio is already on with a
2. Press the power/volume knob to
3. Insert the DVD map disc. See
. 4. A Caution may appear. Press
5. Press NAV.
6. Press MENU, located on the
7. Press
8. Press the Region screen button.
9. Select the correct numbered
map disc inserted, skip to
Step 5.
turn the system on.
Installing the DVD Map Disc
under
Agree to proceed.
screen.
(Enter Destination).
region that contains your final
destination.
.