Chevrolet 2013 Corvette Owner's Manual page 19

STATION NOT FOUND displays.
If both PTY and TA are on, the
audio system searches for stations
with traffic announcements and the
selected PTY.
six presets let you return to your
favorite PTYs. These presets have
factory PTY preset stations. Up to
12 PTYs, six FM1 and six FM2 can
be set. To save a PTY preset:
1. Press FM1 or FM2.
2. Press RDS to enter the
RDS menu.
3. Press RDS ON/OFF to turn
RDS on.
4. Press PTY.
5. Press Select PTY and select the
desired PTY from the list.
6. Press and hold one of the six
presets for more than
two seconds until a beep is
heard. When you press that
numbered preset for less than
two seconds, the set PTY
returns.
7. Repeat the steps for each
preset.
Press the stored PTY preset station
for less than two seconds to recall
it. Then use
The
SCAN to locate a station for that
PTY selection.
This type of
announcement warns of national or
local emergencies and cannot be
turned off. ALERT displays while an
alert announcement plays. The
audio system uses TA volume
during these announcements. To
increase volume, use the VOL up
and down buttons during the
announcement. See Voice
Guidance Volume Settings under
When an alert announcement
comes on the tuned radio station, it
will be heard even if the volume is
muted or a CD is playing. If the CD
player is playing, the player stops
for the announcement and resumes
when the announcement is finished.
If the vehicle has this feature, the
audio system settings that were
adjusted the last time the vehicle
SEEK or
was operated can be recalled. This
feature allows two different drivers
to store and recall their own audio
system settings. The adjusted
settings are recalled by the audio
system and are determined by
which Remote Keyless Entry (RKE)
transmitter (1 or 2) that was used to
enter the vehicle. The number on
the back of the RKE transmitter
corresponds to driver 1 or to
driver 2.
The audio system can store HOME
and AWAY preset stations. HOME
.
and AWAY preset stations allow the
use of one set of preset radio
settings in a local area, and another
set not in the local broadcast area.
This eliminates the need to
reprogram preset stations while
traveling out of the area.