Chevrolet 2013 Corvette Owner's Manual page 18

If tuned to a station broadcasting
RDS information, the station's
Program Service (PS) and Program
Type (PTY) replace the station's
frequency on the status line at the
top of the display. After about
five seconds, if available, the PTY is
replaced on the display by the
station's PTY name. The PTY and
PTY name can be the same or
different.
If the audio system is tuned to a
station that is not broadcasting RDS
information, the station's frequency
remains on the display.
The RDS feature relies upon
receiving specific information from
RDS stations. These features only
work when RDS information is
available.
TA to receive traffic
announcements. TA displays if the
current station broadcasts traffic
announcements. If the current
station does not broadcast traffic
announcements, the audio system
seeks to a station that does and
stops. If no station is found, TA
turns off.
While a traffic announcement plays,
the audio system uses TA volume.
To increase TA volume, use the
VOL up or down buttons during the
announcement. See Guidance
Volume under
.
When a traffic announcement
comes on the current radio station,
it can be heard even if the volume is
muted or a CD is playing. If the CD
player was being used, the CD
stays in the player and resumes
play at the point where it stopped.
Press RDS followed by TA again to
turn TA off.
Press
on, if the current station has a
message, INFO displays. Press
INFO from the preset menu to view
the message. If the whole message
does not display, parts of the
message appear every
three seconds until the message is
completed. Once the complete
message has been displayed, INFO
disappears from the display until
another new message is received.
INFO remains available so that the
entire message an be displayed
again.
seeks stations with certain program
types. This button is used to turn on
and off Program Type (PTY)
features.
With RDS on, press RDS, followed
by PTY. The PTY display turns on.
Press RDS followed by this button
again to turn the PTY display off.
press RDS, then Select PTY. The
PTY menu appears. Use the up and
When RDS is
down arrows to select a PTY.
When the PTY display is on, press
radio stations of the PTY selected.
The last PTY selected is used for
seek and scan modes. If a station
with the selected PTY is not found,
PTY only
With RDS and PTY on,
SEEK or SCAN to find