Engine Maintenance; Preparing The Unit For Storage; Storing The Engine - Generac Portable Products 2500PSI Owner's Manual

ENGINE MAINTENANCE

See the engine owner's manual for instructions on how to
properly maintain the engine.
PREPARING THE UNIT
FOR STORAGE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts and
"freeze" pump action. If you do not plan to use the
pressure washer for more than 30 days, follow this
procedure:
1. Flush detergent siphoning tube by placing the filter into
a pail of clean water while running pressure washer in
low pressure mode. Flush for one to two minutes.
2. Shut off the engine and let it cool, then remove all
hoses. Disconnect spark plug wire from spark plug.
3. Empty the pump of all pumped liquids by pulling the
recoil handle about 6 times. This should remove most
of the liquid in the pump.
Generac Portable Products 2,500 PSI High Pressure Washer
NOTE: To protect the unit from freezing temperatures,
draw RV antifreeze (non-alcohol) into the pump by pouring
the solution into a 3-foot section of garden hose connected
to inlet adapter and pulling recoil handle twice.
4. Store unit in a clean, dry area.
Hose Storage:
• Disconnect hose from spray gun and high pressure outlet
on pump. Drain water from hose and wipe off the hose
with a rag.
• Store the hose on the hose reel as described in "How To
Use the Hose Reel".
Battery Storage:
Store your unit with the DC battery charger plugged in to
keep your battery charged and ready for use.
If you store your pressure washer below freezing
temperatures and the charger cannot be plugged in, charge
the battery for 24 hours prior to storage. Be sure to
recharge the battery once each month to maintain a fully
charged battery.

STORING THE ENGINE

See the engine owner's manual for instructions on how to
properly prepare the engine for storage.
16