Table of Contents
Advertisement
3
.
1
.
4
P
P
T
P
3
.
1
.
4
P
P
T
P
To choose PPTP as the accessing protocol of the internet, please select Internet Access
Setup on the Quick Setup page. Next, choose the PPTP link. The following web page will be
shown.
PPTP Setup
ISP Access Setup
PPP Setup
IPCP
WAN physical type
24
PPTP Link - Click Enable to enable a PPTP client to establish a
tunnel to a DSL modem on the WAN interface.
PPTP Server - Specify the IP address of the PPTP server.
ISP Name - Type in the ISP Name provided by ISP in this field.
Username -Type in the username provided by ISP in this field.
Password -Type in the password provided by ISP in this field.
Scheduler - You can type in four sets of time schedule for your
request. All the schedules can be set previously in Application –
Schedule web page and you can use the number that you have set in
that web page.
PPP Authentication - Select PAP only or PAP or CHAP for PPP.
Always On -Check this box if you want the router keeping
connecting to Internet forever.
Idle Timeout - Set the timeout for breaking down the Internet after
passing through the time without any action.
Fixed IP Address -Type a fixed IP address.
Obtain an IP address automatically – Click this button to obtain
the IP address automatically.
Specify an IP address – Click this radio button to specify some data.
IP Address – Type the IP address.
Subnet Mask – Type the subnet mask.
Check and choose a proper type used for duplex between this device
and other router that you want to communicate. Both sides should
use the same physical type; otherwise, the connection might be
Vigor2100 Series User's Guide
Advertisement
Table of Contents
