Table of Contents
Advertisement
PnP/PCI Configuration
Reset Configuraton Data
Resources Controlled By
X IRQ Resources
PCI/VGA Palette Snoop
INT Pin 1 Assignment
INT Pin 2 Assignment
INT Pin 3 Assignment
INT Pin 4 Assignment
INT Pin 5 Assignment
INT Pin 6 Assignment
INT Pin 7 Assignment
INT Pin 8 Assignment
** PCI Express relative items **
Maximum Payload Size
:Move Enter: Select +/-/PU/PD :Value F10:Save ESC:Exit F1:General Help
Parameter
Reset Configuration Data
Resources Controlled By
PCI/VGA Palette Snoop
INT Pin 1-8 Assignment
Maximum Payload Size
42
Phoenix - Award BIOS CMOS Setup Utility
PNP/PCI Configurations
[Disabled]
[Auto(ESCD)]
Press Enter
[Disabled]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[128]
F5:Previous Values F7:Default Settings
Description
In case a conflict occurs after you assign the IRQs or
after you configure your system, you can enable this
function to allow your system to automatically reset
your configuration and reassign the IRQs, DMAs and I/
O address.
if this option is set to Auto, the BIOS automatically
selects all the devices Plug & Play compatible
specifying their Interrupt and DMA. If you selected the
manual setting, you can specify the device for each
interrupt it is assigned to (ISA o PCI); this is the same
for DMAs.
Enable this option to correct screen color shifts, when
there is a combination of VGA cards, accelerator cards,
or MPEG cards present.
This item allows you to select the payload size for PCI
Express device's maximum TLP (Transmission Level
Point).
Item Help
Menu Level
Default is Disabled.
Select Enabled to
reset Extended System
Configuration Data
ESCD) when you exit
Setup if you have
installed an new add-on
and the system
reconfiguration has
caused such as serious
conflict that the OS
cannot boot
Options
Disabled, Enabled
Auto (ESCD), Manual
Disabled, Enabled
128, 256, 512, 1024, 2048,
4096
Chapter 2
Advertisement
Table of Contents
