Extending Engine Run Time; Canceling A Remote Start - Chevrolet Traverse Owner's Manual

2014
Table of Contents

Advertisement

3. Immediately after completing
Step 2, press and hold
the parking lamps flash. If the
vehicle's lights cannot be seen,
press and hold
for at least
four seconds.
When the vehicle starts, the parking
lamps will turn on and remain on as
long as the engine is running. The
doors will be locked and the climate
control system will operate
automatically if the vehicle has the
automatic system, or at the same
setting as when the vehicle was last
turned off.
If the vehicle has an automatic
climate control system and heated
seats, the heated seats turn on
during colder outside temperatures
and shut off when the key is turned
to ON/RUN. See Heated and
Cooled Front Seats on page 3-8.
The rear window defogger and
heated mirrors, if the vehicle has
them, turn on during colder outside
temperatures and turn off when the
key is turned to ON/RUN.
After entering the vehicle during a
remote start, insert and turn the key
until
to the ON/RUN position to drive the
vehicle.
If the vehicle is left running it
automatically shuts off after
10 minutes unless a time extension
has been done.

Extending Engine Run Time

To extend the engine run time by
10 minutes, repeat Steps 1 3 while
the engine is still running. The
engine run time can only be
extended if it is the first remote start
since the vehicle has been driven.
Remote start can be extended
one time.
If the remote start procedure is used
again before the first 10-minute time
frame has ended, the first
10 minutes will immediately expire
and the second 10-minute time
frame will start.
Keys, Doors, and Windows
For example, if
pressed again after the vehicle has
been running for five minutes,
10 minutes are added, allowing the
engine to run for a total of
15 minutes.
A maximum of two remote starts or
remote start attempts are allowed
between ignition cycles.
After the vehicle's engine has been
started two times using the remote
start button, the ignition must be
turned on and then back off before
the remote start procedure can be
used again.

Canceling a Remote Start

To manually shut off a remote start:
Aim the RKE transmitter at the
vehicle and press
parking lamps turn off.
Turn on the hazard warning
flashers.
Turn the ignition switch on and
then off.
2-5
and then
are
until the

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2014 traverse

Table of Contents