Preparation For Use; Unpacking And Setup; Power Source - Electrohome EANOS502 Instruction Manual

Nostalgia music centre

Hide thumbs Also See for EANOS502:

Instruction manual (19 pages)

Instruction manual (42 pages)

Table of Contents

Available languages

UNPACKING AND SETUP

•

Carefully remove the unit from the display carton and

remove all packing material from the unit

•

Unwind the AC power cord and extend it to its full length

•

Unwind the FM Antenna wire and extend it to its full

length

•

Place the unit on a stable, level surface, close to an AC

outlet, out of direct sunlight, and away from sources of

excess heat, dust, moisture, humidity, or strong magnetic

fields

•

Raise the lid to expose the phonograph. The phonograph

has been secured for shipment with a transit screw. Use

a coin or screwdriver to TURN THE TRANSIT SCREW

CLOCKWISE. This will allow the turntable to "float" and

turn freely

•

Remove the opaque white plastic stylus cover from the

phonograph stylus by sliding it in the direction of the

arrow.

•

Discard the stylus cover.

•

Remove the twist-tie that was used to secure the tone

arm during shipment.

•

Release the tone arm lock lever.

•

Connect the plug to your AC outlet, as shown below.

POWER SOURCE

This system is designed to operate on normal 120V 60Hz

AC only. Attempting to operate this system from any other

power source may cause damage to the system, and such

damage is not covered by your warranty.

Note: This system is equipped with a polarized AC power

plug having one blade wider than the other. This is a

safety feature. If this plug does not fit into your existing

AC outlet, do not try to defeat this safety feature by

altering the wide blade to make it fit into your outlet. If

this plug will not fit into your outlet, you probably have

an outdated non-polarized AC outlet. Have the obsolete

outlet changed by a qualified licensed electrician.