Preparation For Use; Unpacking And Setup; Power Source; Battery Installation Of Remote Control - Electrohome WELLINGTON EANOS502 Instruction Manual

Retro stereo system

Hide thumbs Also See for WELLINGTON EANOS502:

Instruction manual (27 pages)

Instruction manual (19 pages)

Table Of Contents

Table of Contents

UNPACKING AND SETUP

•

Carefully remove the unit from the display carton

and remove all packing material from the unit

•

Unwind the AC power cord and extend it to its full

length

•

Unwind the FM Antenna wire and extend it to its

full length

•

Place the unit on a stable, level surface, close to

an AC outlet, out of direct sunlight, and away from

sources of excess heat, dust, moisture, humidity, or

strong magnetic fields

•

Raise the lid to expose the phonograph. The phonograph has been secured for shipment with a transit

screw. Use a coin or screwdriver to TURN THE TRANSIT SCREW CLOCKWISE. This will allow the turntable

to "float" and turn freely.

•

Remove the opaque white plastic stylus cover from the

phonograph stylus by sliding it in the direction of the arrow.

•

Discard the stylus cover.

•

Remove the twist-tie that was used to secure the tone

arm during shipment.

•

Release the tone arm lock lever.

•

Connect the plug to your AC outlet, as shown below.

POWER SOURCE

This system is designed to operate on normal 120V

60Hz AC only. Attempting to operate this system

from any other power source may cause damage to

the system, and such damage is not covered by

your warranty.

Note: This system is equipped with a polarized

AC power plug having one blade wider than the

other. This is a safety feature. If this plug does not

fit into your existing AC outlet, do not try to defeat

this safety feature by altering the wide blade to

make it fit into your outlet. If this plug will not fit

into your outlet, you probably have an outdated

non-polarized AC outlet. Have the obsolete outlet

changed by a qualified licensed electrician.