Wheel Drive Belt Guards Installation - Troy-Bilt 753 Service Manual

Servicing the Troy-Bilt Wide Cut 33" Combination Mower
14.10. Remove the square key from the axle. See Fig-
ure 54.
Square Key
Figure 54
14.11. Repeat for the other wheel.
14.12. Using a ½ inch socket and opened end wrench
remove the top locknuts, flat washers and
screws securing the transmission to the frame.
See Figure 55.
Transmission Mounting Bolts (4)
Figure 55
NOTE: Support the transmission during this pro-
cedure.
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
14.13. Remove the transmission from the unit for ser-
15.
On older units the long run of the wheel drive belt cre-
ates several issues.
•
•
16
vice. See Figure 56.
Figure 56
NOTE: Contact Tecumseh-Peerless for trans-
mission service information during the warranty
period. Model number information is located on
the right side of the transmission. See Figure
57.
Transmission Model Number
Figure 57
INSTALLATION OF WHEEL DRIVE BELT
GUARDS - UPDATE
NOTE: Current production units have additional
belt guards installed at the factory. This update
will cover older units without pulley belt guards.
The belt may come off one of the pulleys.
The belt may not fully disengage from the engine
pulley, causing engine creep or hard shifting