Rear View Camera - Vauxhall Ampera 2014 User Manual

Vauxhall ampera 2014
Table of Contents

Advertisement

126
Driving and operating

Rear view camera

9 Warning
The rear view camera system
does not display pedestrians,
cyclists, animals or any other
object located outside the
camera's field of view, below the
bumper or under the vehicle.
Do not reverse the vehicle using
only the rear view camera screen
or by using the screen during
longer, higher speed reversing
manoeuvres, or where there could
be cross-traffic. Perceived
distances may be different from
actual distances.
Failure to use proper care before
reversing may result in injury,
death or vehicle damage. Always
check before reversing by
physically checking behind and
around the vehicle.
The rear view camera system can
assist the driver when reversing, by
displaying a view of the area behind
the vehicle.
System operation
When shifting into R, the area behind
the vehicle is shown in the Colour-
Info-Display with the message Check
Surroundings For Safety. The
previous screen displays for approx.
10 seconds after shifting out of R.
To see the previous screen sooner,
do one of the following:
■ Press a button on the Infotainment
system.
■ Shift into P.
■ Reach a vehicle speed of 5 mph.
Activation and deactivation
To turn the rear view camera system
on or off:
1. Shift into P.
2. Press the CONFIG button on the
instrument panel.
3. Select Display.
4. Select Camera. When a
checkmark appears next to the
camera, the rear view camera
system is on.
Symbols
The navigation system may have a
feature showing symbols on the
navigation screen while using the rear
view camera. The ultrasonic parking
assist system must not be disabled, to
enable use of the caution symbols. An
error message may be displayed if
ultrasonic parking assist has been
disabled and the symbols have been
turned on.
The symbols appear and may
eventually cover an object shown by
the navigation screen when an object
is detected by the ultrasonic parking
assist system.
To turn the symbols on or off:
1. Shift into P.
2. Press the CONFIG button on the
instrument panel.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents