Hama AV Selector 310 Operating Instruction page 10

00042549bda 21.12.2005
L Operating instruction AV Selector 310 L
Connect your television or monitor to the TV/monitor output.
Mains supply
Insert the small plug of the supplied power supply unit into the socket on the
right side of the AV 310. Plug the power supply unit into the socket (230V).
The red power LED on the front side of the AV 310 now illuminates.
Use
1. Observe the following:
Set your television to AV.
• Input A has the highest priority. If a video signal is detected at this input,
it takes precedence over inputs B and C. If, for example, you would like to
use the camcorder at input A, you only have to switch the camcorder to
playback mode.
• Input B has the second highest priority. If there is switching voltage at
this input, B takes precedence over input C. If you would like to use input
B (e.g. the video recorder), switch the video recorder to playback mode. If
an appliance is connected to input A at the same time, it must be swit-
ched off.
• Input C has the lowest priority. The image on this input is only displayed, if
there is no video signal or switching voltage at input A or B.
The green LED on the front side indicates which inputs are interconnected.
11:20 Uhr Seite 10
8