Attaching Lcd Projector; Connecting Cables; Connect The Cables To The Projector - Hitachi HAS-K250 User Manual

Attach the LCD projector to which the bracket (B) has been attached to the
adjusting block (Q).
Tighten the four M4 x 8 round head screws (H).
Tightening torque: 0.98 N•m (10 kgf•cm)
(Q)
(B)
(LCD projector front panel)
(H)
■ Never use screws other than those designated.
Failure to heed this warning may cause the projector to fall or other hazard
resulting in damage or injury.

Connect the cables to the projector.

HAS-K250
(H)
WARNING
Connect as shown in the above fi gure.
13
(LCD projector rear panel)
(Q)
(B)