TO INSTALL THE bLADE GUARD AND ANTI-
KICKbACK PAwLS
See Figures 14 - 16.
wARNING:
Replace dull or damaged anti-kickback pawls. Dull or
damaged pawls may not stop a kickback increasing the
risk of serious personal injury.
NOTE: Anti-kickback pawls should only be installed for
through cuts.
Unplug the saw.
Raise the saw blade by turning the height/bevel adjusting
handwheel clockwise.
Place spreader/riving knife in "up" position.
To install blade guard:
Lift the guard lever up to unlock.
With the front of the blade guard raised, lower the back
of the guard into the middle hole of the spreader/riving
knife. Push the front of the guard down until it is paral-
lel to the table (see figure 15). If the blade guard is not
parallel to the table, the riving knife is not in the spreader
(or "up") position.
Lock the guard in place by pushing the guard lever down.
To install anti-kickback pawls:
Press and hold the button on the right side of the anti-
kickback pawls.
Align the slot in the pawls over the rear hole in the spreader/
riving knife.
Push the pawl handle down snapping them into place
and release the button.
NOTE: Pull on the pawl handle to make sure pawls are
securely locked.
NOTE: Blade alignment with the spreader can be adjusted
for different blade widths. Refer to: To Check and Align the
Spreader/Riving Knife and Saw blade. Check the blade guard
assembly for clearances and free movement.
ASSEMbLy
blade
Guard
Pawl
Handle
anti-kickback
Pawls
21
Guard
leVer
button
correct
incorrect
Fig. 14
Fig. 15
Fig. 16