Electrical Connection (Uk Only) - DeLonghi EC 250 Instructions For Use Manual

Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your
home, if you are in any doubt about your supply contact your local electricity company.
The lexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity.
Should this plug not it the socket outlets in your home, it should be cut of and replaced with a suitable plug, following
the procedure outlined below.
Note: Such a plug cannot be used for any other appliance and should therefore be properly disposed of and not left
where children might ind it and plug it into a supply socket - with the obvious consequent danger.
Please note: We recommend the use of good quality plugs and wall sockets that can be switched of when the machine
is not in use.
IMPORTANT: The wires in the mains lead itted to this appliance are coloured in accordance with the following code:
GREEN AND YELLOW
BLUE
BROWN
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identi-
fying the terminals in your plug, proceed as follows:
- The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with
the letter E or by the earth symbol
- The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured
black.
- The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured
red.
When wiring the plug, ensure that all strands of wire are securely retained in each terminal. Do not forget to tighten
the mains lead clamp on the plug. If your electricity supply point has only two pin socket outlets, or if you are in doubt,
consult a qualiied electrician.
Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualiied electri-
cian and should only be replaced with a lexible cord of the same size.
After replacement of a fuse in the plug, the fuse cover must be reitted. If the fuse cover is lost, the plug must not be used
until a replacement cover is obtained. The colour of the correct replacement fuse cover is that of the coloured insert in
the base of the fuse recess or elsewhere on the plug. Always state this colour when ordering a replacement fuse cover.
Only 13amp replacement fuses which are asta approved to B.S. 1362 should be itted.
This appliance conforms to the Norms EN 55014 regarding the suppression of radio interference.

Electrical connection (uk only)

EARTH
NEUTRAL
LIVE
or coloured green or green and yellow.
Warning - this appliance must be earthed
2
Green and Yellow to Earth
Blue to
neutral
Cord Clamp
13 amp
Fuse
Brown to
live