MSI MS-7798 (v2.x) Manual page 46

BIOS Setup
Advanced
▶ PCI Subsystem Settngs
Press <Enter> to enter the sub-menu.
▶ PCIE GEN3
Ths tem s used to enable/ dsable the PCIe generaton 3 support.
▶ PCI Latency Tmer
Controls how long each PCI devce can hold the bus before another takes over.
When set to hgher values, every PCI devce can conduct transactons for a longer
tme and thus mprove the effectve PCI bandwdth.
▶ ACPI Settngs
Press <Enter> to enter the sub-menu.
▶ ACPI Standby State
Specfies the power savng mode for ACPI functon
[S1] Sleep Mode. Hardware remans on.
[S3] Suspend to RAM. Turns off hardware. (Recommended)
▶ Power LED
Configures how the system uses power LEDs on the case to ndcate sleep/
suspend state.
[Dual]
[Blnkng]
▶ Integrated Perpherals
Press <Enter> to enter the sub-menu.
▶ Onboard LAN Controller
Ths tem allows you to enable/ dsable the onboard LAN controller.
▶ LAN Opton ROM
Ths tem s used to decde whether to nvoke the Boot ROM of the onboard LAN.
▶ Network Stack
Ths tem s used to enable/ dsable UEFI network stack.
▶ Ipv4 PXE Support
Ths tem appears when you set "Enabled" n [Network Stack] field and s used to
enable/ dsable the Ipv4 PXE boot support.
▶ Ipv6 PXE Support
Ths tem appears when you set "Enabled" n [Network Stack] field and s used to
enable/ dsable the Ipv6 PXE boot support.
▶ SATA Mode
Ths tem s used to specfy IDE/ AHCI mode for SATA port.
Important
You cannot swtch between AHCI and IDE f you already have your operatng system
nstalled. If you have nstalled your OS usng AHCI and you clear your BIOS/reset to
2-6
The power LED changes ts color to ndcate the sleep/suspend
state.
The power LED blnks to ndcate the sleep/suspend state.