Assembly - Ryobi RY08544 Operator's Manual

UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list are
included.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-860-4050 for assistance.
PACKING LIST
Blower
Upper Blower Tube
Sweeper Nozzle
High Velocity Nozzle
Vacuum Handle
Vacuum Handle Knobs (2)
Upper and Lower Vacuum Tubes
Vacuum Tube Screws (2)
Vacuum Bag Assembly
Vacuum Bag Adaptor
2-Cycle Engine Oil
Operator's Manual
NOTE: Read and remove all hang tags and store with your
operator's manual.
WARNING:
If any parts are damaged or missing do not operate
this tool until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create accessories
not recommended for use with this tool. Any such alteration
or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
ASSEMBLING THE BLOWER TUBES
See Figure 2.
 Align raised tabs on main housing to the slots on upper
tube; slide together and tighten securely by twisting.
Check tightness after initial run and retighten if needed.
 To remove the tubes, rotate the tubes to unlock them and
remove from the blower housing outlet.

ASSEMBLY

INSTALLING THE VACUUM HANDLE
See Figure 3.
 Lay unit on side as shown.
 Insert vac handle into the base of unit.
 Secure vac handle in place using two knobs as shown.
SWEEPER NOZZLE
ADAPTOR
VACUUM BAG
9
UPPER BLOWER
VACUUM
HANDLE
TUBE
Fig. 2
VACUUM
HANDLE
KNOBS
Fig. 3
Fig. 4