Valcom PagePac V-5330100 User Manual

®
PagePac
by
INTRODUCTION
P-TEC Voice Paging Speakers are suitable for
voice paging as well as background music. The
V-5330200 is a 70 volt model with adjustable taps
and volume control. The V-5330100 is a voice coil
(45 Ohm) 3.4 volt model with volume control.
P-TEC speakers consist of a 3.6 inch cone
speaker mounted in a unique surface-mount baf-
fle. The baffle is designed for mounting on
acoustic tile, such as those normally found in sus-
pended-ceilings; and can be mounted without
cutting large holes in the tile. The mounting pins
can be removed for mounting in a hard ceiling.
The speaker housing has screw holes for securing
speaker without mounting pins. Although the
P-TEC speakers are designed especially for stan-
dard suspended ceilings, they can be used on
many types of ceiling materials.
DIMENSIONS/WEIGHT
• 8"Dia. x 2.5"D (20.32cm x 6.35cm)
Voice Coil .75 lbs. (.34 kg)
70 Volt 1.25 lbs. (.56 kg)
INSTALLATION
Selecting the Power-Tap Wire (70V)
Note: For the V-5330100 Speakers (Voice Coil),
begin at Suspended Ceiling Installation.
1. Remove the Quick-Connect connector from
the accessory pack.
2. Select the desired power-tap wire:
Yellow = 1/4W
Red = 1/2W
Green = 1W
White = 2W
Blue = 4W
Note: Refer to spacing chart (Figure 6) for recom-
mended speaker spacing.
P-TEC VOICE PAGING SPEAKERS
V-5330100 (VOICE COIL)
V-5330200 (70 VOLT)
Figure 1. P-TEC Paging Speaker (70V shown)
3. Install the Quick-Connect connector on the
wire. Use pliers to close the connector over
the wire. The connector can be removed by
prying it open with a screwdriver, and can be
reused several times (see Figure 2).
Figure 2. Attaching the Reuseable Quick-Connect
Connector (V-5330200 Only)
1
Issue 2
Back Box (Optional)
Volume Control
Reusable
Quick-Connect
Connector
Tap Wire
947165