Adjustments; Pivot Adjustments; Travel Pivot Adjustment; Bevel Pivot Adjustment - Ryobi TS1342LBF Operator's Manual

WARNING:
Before performing any adjustment, make sure the tool is
unplugged from the power supply. Failure to heed this
warning could result in serious personal injury.
The compound miter saw has been adjusted at the
factory for making very accurate cuts. However, some of
the components might have been jarred out of alignment
during shipping. Also, over a period of time, readjustment
will probably become necessary due to wear. After unpacking
the saw, check the following adjustments before you begin
using saw. Make any readjustments that are necessary and
periodically check the parts alignment to make sure that the
saw is cutting accurately.
CAUTION:
Do not start the compound miter saw without checking
for interference between the blade and the throat plate.
Damage could result to the blade if it strikes the throat
plate during operation of the saw.

PIVOT ADJUSTMENTS

NOTE: These adjustments were made at the factory and
normally do not require readjustment.

TRAVEL PIVOT ADJUSTMENT

 The saw arm should rise completely to the up position
by itself.
 If the saw arm does not raise by itself or if there is play in
the pivot joints, have saw repaired at your nearest RyOBI
AUTHORIZED SERVICE CENTER.

BEVEL PIVOT ADJUSTMENT

 The compound miter saw should bevel easily by loosening
the bevel lock knob and tilting the saw arm to the left.
 If movement is tight or if there is play in the pivot, have saw
repaired at your nearest RyOBI AUTHORIZED SERVICE
CENTER.
DEPTH STOP
The depth stop limits the blade's downward travel. It
allows the blade to go below the miter table enough to
maintain full cutting capacities.
The depth stop is factory set to provide maximum cut-
ting capacity for the 10 in. blade provided with the saw.
Therefore, the saw with blade provided should never need

adjustments.

ADJUSTMENTS
POSITIVE STOP ADJUSTMENTS
See Figure 35.
NOTE: These adjustments were made at the factory and
normally do not require readjustment.
To adjust:
 Unplug the saw.
 Using two wrenches (one on the lock nut and one for
the positive stop adjustment screw), loosen the lock nut
securing the positive stop adjustment screw.
 Loosen the bevel lock knob by turning the knob
counterclockwise.
 Square the blade to the miter table as described in the
Assembly section of this manual.
 Retighten bevel lock knob. Next, retighten lock nut
securing the positive stop adjustment screw. Recheck
blade-to-table alignment.
NOTE: The above procedure can be used to check blade
squareness of the saw blade to the miter table at both 0°
and 45° angles.
The saw has two scale indicators, one on the bevel scale
and one on the miter scale. After squaring adjustments have
been made, it may be necessary to loosen the indicator
screws and reset them to zero.
poSitive Stop
adJuStment
Screw For
0 angLeS
°
8
beveL Lock
knob
poSitive Stop
adJuStment
Screw For
45 angLeS
°
Lock nut(S)
Fig. 35