Input Menu; Olor Space - Hitachi CP-X608 User's Manual And Operating Manual

INPUT Menu

INPUT Menu
From the INPUT menu, items shown in the table below can
be performed.
Select an item using the ▲/▼ cursor buttons on the
projector or remote control, and press the ► cursor button
on the projector or remote control, or ENTER button on
the remote control to execute the item. Then perform it
according to the following table.
Item
PROGRESSIVE
VIDEO NR
3D-YCS
COLOR SPACE
(continued on next page)
3
Using the ▲/▼ buttons switches the progress mode.
TV ó FILM ó TURN OFF
• This function is performed only for an interlaced signal of a VIDEO
input, an S-VIDEO input or COMPONENT VIDEO input of 55i
(480i), 65i (576i) or 5i (080i) signal.
• When TV or FILM is selected, the screen image will be sharp.
FILM adapts to the -3 Pull-Down conversion system. But these
may cause a certain defect (for example, jagged line) of the picture
for a quick moving object. In such a case, please select TURN OFF,
even though the screen image may lose the sharpness.
Using the ▲/▼ buttons switches the noise reduction mode.
HIGH ó MID ó LOW
• This function performs only at a VIDEO input, an S-VIDEO or
COMPONENT VIDEO input of 55i(480i), 65i(576i) or 5i (080i)
signal.
• When this function is excessive, it may cause a certain
degradation of the picture.
Using the ▲/▼ buttons switches the 3D-YCS mode.
STILL ó MOVIE ó TURN OFF
• This function performs only at a VIDEO input of NTSC, and PAL.
• MOVIE is the mode for images with a lot of motions like movies,
and STILL is the mode for images with few motions or completely
still ones like slides.
Using the ▲/▼ buttons switches the mode for color space.
AUTO ó RGB ó SMPTE40 ó REC709 ó REC60
• This item can be selected only for an RGB signal or a component
video signal (except 55i (480i), 65i (576i) and SCART RGB).
• The AUTO mode automatically selects the optimum mode.
• The AUTO operation may not work well at some signals. In such a
case, it might be good to select a suitable mode except AUTO.
Description