Table of Contents
Advertisement
R3
d.
Test the opening temperature by placing th.e ttterrnostat in the water.
Raise to the temperature stamped on bottom of thermostat.
e.
If thermostat fails to open, fit new thermostat.
Allow the temperature
to cool.
If it sticks open, renew new thermostat.
f.
Install thermostat with new gasket and secure thermostat housing
to cylinder head.
g.
Replace coolant, remove, or if system was drained, fill expansion tank
to within one inch from top of tank with clean ftesh water and a suitable
corrosion inhibitor or antifreeze solution.
h.
Start engine and run until normal operating temperature is reached.
Stop engine, carefully remove expansion tank filler cap and add coolant
as required.
9.
REMOVE SEA WATER PUMP (Timing cover mounted)
a.
Remove hoses from pump.
b.
Remove the four bolts securing pump to adapter plate, and pull pump
away from plate.
c.
Remove drive tang between water pump coupling and fuel pump drive gear.
d.
To replace the pump, reverse the procedure above, using sealing compound.
(Rector seal or its equivalent on inlet and discharge hose connections
to prevent air leaks.
Secure with hose clamps) •.
10.
ENGINE HOT WATER HEATER INSTALLATION
10
~"'Ore:
__
:;URg._!A~~
• REQ'D
WHEN_"!2_T
_~R. _H~TE:R
!N,;,TALLED
A BO.E.....ENGI . ."'E •
7
-I\IHEN
R:EM'?T~
~UR('E.
TANK
/
!-~-.STA~~~E~?~ ~-~( -'IS~S~;'RE:~~~UR~
(A~_
PARr
21~7~
_:>'?
N9T
U..:-f;
TO
F'I'...~
EN~I!'IE
'NI'TH
C0')_.\NT.
~>~,ON_U
__
A!)_.
A~ _~I
R . B_E[;)
POINT
Advertisement
Chapters
Table of Contents
