Table of Contents
Advertisement
The Sunbeam® Advanced Bark Control Collar has been designed to maximize battery
life and has a SLEEP MODE that it enters if no user input or barking is detected.
STEP 2: Set correction level by pressing and holding (approximately 2 seconds) the
Main Control Button until a gREEN LED illuminates at the desired setting.
When a gREEN LED is illuminated press once the Main Control Button to toggle
to the next correction level. Once a correction level is chosen the gREEN LED will
turn off and the system has entered SLEEP MODE.
Note: It is recommended to start on the LOW setting and monitor your dog's
behavior before determining if a higher correction level is needed.
STEP 3: Attach collar to your dog as you did in the COLLAR FITTING stage.
SPECIAL OPERATING NOTES
SLEEP MODE: This is the normal operating mode of the bark control collar. The
system has been designed to maximize battery life. You can verify the status of
the system by pressing and holding the Main Control Button for 2 seconds.
The Sunbeam® Advance Bark Control Collar retains the LAST correction level
setting and will resume this mode when the unit is turned on.
The LED of the setting chosen will illuminate gREEN when a bark has been
detected and a correction is being administered.
OvER CORRECTION MODE: If excessive barking is detected the bark control
system will enter a mode designed to shut down the system.
The LED of the selected setting will illuminate RED and will automatically reset.
You can manually reset the system by pressing and hold the Main Control Button.
LOW BATTERY MODE: All 3 LEDs will flash RED for 5 seconds when the battery
needs to be replaced.
TRAINING GUIDE
Proper training is essential to achieving the best results from the Sunbeam®
Advanced Bark Control Collar for you and your dog. When first starting to use the
bark control collar, you should closely monitor your dog's reaction when barking
behavior is exhibited.
When you begin using the bark control collar, your dog should be inside a
protected area. The protected area should not be a cage, crate, or kennel. If
outside, your dog should be in a safe protected area so that your dog is unable to
run away when they receive the correction from the bark control collar.
6
Hide quick links:
Advertisement
Table of Contents
