Battery Installation; How It Works; Operating Instructions - Sunbeam Bark Control Collar Instruction Manual

How it Works:

The Sunbeam® Advanced Bark Control Collar has a proprietary bark detection
system that uses sensors and a voice mapping system to determine barking
behavior. This specially designed system ensures that a correction is
administered only when unwanted barking behavior is occurring. The system
also has been designed to prevent continuous corrections if excessive barking
is detected. AN OvER CORRECTION MODE causes the system to turn off and
automatically resets.

OPERATING INSTRUCTIONS

Battery Installation:

IMPORTANT: This step is to be completed when the collar is NOT on your dog.
• Remove two screws securing the battery compartment using a cross head or
Phillips head screwdriver. (
• Lift battery compartment from main body of
bark collar. (
fig. 2)
• Insert two CR2032 Lithium coin batteries into
battery compartment. Batteries should be
placed with the positive side facing down.
IMPORTANT: Follow orientation as described on
graphics illustrated on battery compartment. (
• Replace battery compartment with two CR2032
Lithium coin batteries back into main body.
Note: The battery compartment can only be
assembled in one orientation, do not force
closed.
• Tighten the two screws using the cross head
screwdriver, do not over tighten.
• To test the unit turn on by pressing and holding
the main control button for 4 seconds. The unit
will beep twice and flash twice leaving one LED
illuminated to indicate which correction level is
in use.
• To turn off the unit, press and hold the main control button for 4 seconds. The
unit will beep twice and flash twice leaving no LEDs illuminated indicating the
unit is off.
fig. 1)
fig. 3)
3
figure 1
figure 2
figure 3