Table of Contents
Advertisement
7. Ensure that:
The tops of all cards and filler brackets are flush with the alignment bar.
l
The notch in the top of the card or filler bracket fits around the alignment guide.
l
8. Secure the card(s) in the computer.
NOTICE:
Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer cover from closing properly or
cause damage to the equipment.
9. Connect any cables that should be attached to the card.
See the documentation that came with the card for information about the card's cable connections.
NOTICE:
To connect a network cable, first plug the cable into the network device and then plug it into the computer.
10. Close the computer cover, reconnect the computer and devices to electrical outlets, and then turn them on.
11. Install any drivers required for the card as described in the card documentation.
Removing a PCI Express Card
1. Follow the procedures in
"Before You
2. If necessary, disconnect any cables connected to the card.
3. Gently pull back the securing tab, grasp the card by its top corners, and then ease it out of its connector.
4. If you are removing the card permanently, install a filler bracket in the empty card-slot opening.
If you need a filler bracket, see "Contacting Dell" in your Owner's Manual.
NOTE:
Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the computer. The brackets also keep dust
and dirt out of your computer.
NOTICE:
To connect a network cable, first plug the cable into the network device and then plug it into the computer.
5. Close the computer cover, reconnect the computer and devices to electrical outlets, and then turn them on.
6. Remove the card's driver from the operating system.
Flash Card Reader
For information on using the Flash Card Reader, see "Using a Flash Card Reader" in your Owner's Manual.
Removing a Flash Card Reader
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
Begin."
Advertisement
Table of Contents
