Table of Contents
Advertisement
Home Wireless-G USB Adaptor
4. The Wireless Mode screen shows a choice of two wireless modes. Click the Infrastructure Mode radio
button if you want to connect to a wireless router or access point. Click the Ad-Hoc Mode radio button if you
want to connect directly to another wireless device without using a wireless router or access point. Enter the
SSID for your network.
Click the Next button to continue or the Back button to return to the previous screen.
Infrastructure Mode - This mode allows wireless and wired networks to communicate through an access
point.
Ad-Hoc Mode - This mode allows wireless-equipped computers to communicate directly with each other. No
access point is used.
SSID - This is the network name. It must be used for all the devices in your wireless network. It is case-
sensitive. It should be a unique name to help prevent others from entering your network.
5. The Ad-Hoc Mode Settings screen will appear. If you chose Infrastructure Mode, go to Step 6 now. If you
chose Ad-Hoc Mode, select the correct operating channel for your network from the Channel drop-down
menu. Then, select the Network Mode from the drop-down menu. Click the Next button, and go to Step 6.
Click the Back button to change any settings.
Channel - The channel you choose should match the channel set on the other devices in your wireless
network. If you are unsure about which channel to use, keep the default channel.
Network Mode - Select Mixed Mode, and both Wireless-G and Wireless-B computers will be allowed on the
network, but the speed may be reduced. Select G-Only Mode for maximum speed, but no Wireless-B users
will be allowed on the network.
Chapter 6: Using the Wireless Network Monitor
Creating a New Profile
Figure 6-16: Wireless Mode for New Profile
Figure 6-17: Ad-Hoc Mode Settings for New Profile
23
Advertisement
Table of Contents
