User Settings - Trane Nexia TCONT624AS42DA User Manual

User Settings

User Settings allow the user to customize various settings on the 624 control. To access User Settings simply press
the Menu button once and "User Settings" will be displayed. To enter the User Settings menu, press the Select button,
then use the Next button to navigate through the options below. The default setting will be shown in brackets. After
each selection press the Done button to save changes.
Setting
Temperature Scale
Cooling RH Setpoint
Smart Continuous Fan
Continuous Fan Airflow
Fan Circulate On Time
Local Schedule Enable
Max Heat Setpoint
Min Cooling Setpoint
H/C Delta
Once all selections have been made, press the Done button to exit and return to Menu. Press Next to navigate to the next setting.
Setting
ESM Heat Setpoint
ESM Cooling Setpoint
Once all selections have been made, press the Done button to exit and return to Menu. Press Next to navigate to the next setting.
Setting
Screen Timeout
Backlight Timeout
Backlight On Percent
Backlight Off Percent
Buzzer Enable
Security
Once all selections have been made, press the Done button to exit and return to Menu. Press Next to navigate to the next setting.
4
Range
[Fahrenheit], Celsius
30% - 60% [50%]
Yes, [No]
35% - 100% [50%]
1 - 59 minutes, [Off]
[Yes], No
55 - [90] Degrees
[60] - 99 Degrees
[3] - 15 Degrees
Range
55 - 90 degrees [62]
60 - 99 Degrees [85]
Range
[0] - 90 Seconds
0 - 90 Seconds [20]
0 - [100] Percent
[0] - 100 Percent
[Yes], No
[Unlocked], Display Lock, Guest
Access
User Guide
Thermostat
Select the temperature display scale
Select the desired indoor relative humidity during cooling mode. Dehu-
midification must be enabled in the Installer Settings for this option to be
available.
If yes is selected, continuous fan mode is disabled when indoor humidity
exceeds the Cooling RH Setpoint
Select the desired fan speed when the Fan Mode selected is Continuous
(variable speed blower required)
Select the desired amount of time the fan will cycle per hour when the Fan
Mode selected is Circ
Select whether scheduling will be enabled or disabled
Select the highest heating setpoint allowed
Select the lowest cooling setpoint allowed
Select the minimum deadband between Heating and Cooling setpoints
Energy Savings Mode
Select the desired Heating Setpoint when ESM (Energy Savings Mode) is
selected
Select the desired Cooling Setpoint when ESM (Energy Savings Mode) is
selected
Display
Select how long after the last button press before the screen timeouts to a
minimized screen
Select how long after the last button press before the backlight dims
Select the screen brightness when the backlight is lit
Select the screen brightness when the backlight timeout expires
Select whether button presses are audible
Select security level
• Unlocked - Enables selection of all menus and settings
• Display Lock - Disables selection of all menus and settings
• Guest Access - Disables selection of all menus and settings except the
following: Raise or lower heating or cooling setpoint +/- 5 degrees and
change system mode
Note: When Display Lock or Guest Lock is selected a lock icon will appear
next to the up arrow.
Note: To disable Display Lock or Guest Access, press and hold the up
and down arrows until the lock icon disappears.
Description
Description
Description