Front Panel Jacks And Connections - Hitachi 55DMX01WD Operating Manual

FRONT PANEL JACKS AND CONNECTIONS

The front panel jacks are provided as a convenience to allow you to easily connect a VCR, PC or camcorder as shown in the
following examples:
AUDIO IN
VIDEO 3/PC2
S-VIDEO
VIDEO L/(MONO) R
VIDEO 3
A/V Cable and
S-INPUT Cable
(Optional)
V L R
S-VIDEO
OUTPUT
Back of VCR
NOTE: Completely insert connection cord plugs when connecting to front panel jacks. If you do not, the played back picture may
be abnormal. If you have an S-VHS VCR, use the S-INPUT cable in place of the standard video cable. If you have a
mono VCR, insert the audio cable into the left audio jack of your TV. INPUT 3 audio can be used for PC INPUT 2 audio
when a PC INPUT 2 is connected.
Optional adapter for *Apple ® Macintosh ® computers. If the optional AESP model G301/U Macintosh to VGA ® adapter
NOTE:
connector is configured and connected between Macintosh video out and the Rear Projection Television video in, the
Macintosh is "forced" to boot in 640 x 480/60 Hz or 800 x 600/60 Hz mode (set mode) because the operational adapter
correctly manipulates the Macintosh sense pins.
For the optional adapter to work, it's DIP switch settings should be # 2, 3, 6, 7 = ON and # 1, 4, 5, 8, 9, 10 = OFF.
See below: Example - See Switch Instructions for details.
Mode 5 = 2367 (SVGA 800 x 600/60 Hz configuration)
Composite Separate Sync
SW1 SW2
ON
OFF
INPUT MENU VOL- VOL+ CH- CH+
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11
TV/PC EXIT SELECT
PC2
Audio Cable
(Optional)
Back of PC
(VGA 640 x480/60 Hz configuration)
SW3 SW4 SW5 SW6
ON ON
OFF OFF
AUDIO IN
VIDEO 3/PC2
S-VIDEO
VIDEO L/(MONO) R
INPUT MENU VOL-
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11
TV/PC EXIT SELECT
PC2
VIDEO 3
D-SUB 15 Pin
RGB Cable
(Optional)
PC
AUDIO OUT
SW7 SW8 SW9 SW10
ON
OFF OFF OFF
9
AUDIO IN
VIDEO 3/PC2
S-VIDEO
VIDEO L/(MONO) R
VOL+ CH- CH+
5
10
15
VIDEO 3
S-VHS Video Camera Output
INPUT MENU VOL- VOL+ CH- CH+
4 3 2 1
9 8 7 6
14 13 12 11
TV/PC EXIT SELECT
PC2