Table of Contents
Advertisement
USING THE REMOTE TO CONTROL
SET-TOP-BOX/SATELLITE RECEIVER FUNCTIONS
Operating the precoded function for your satellite receiver.
This remote is designed to operate different types of set-top-box/satellite systems. You must first program the remote to match the
remote system of your set-top-box/satellite receiver. (refer to page 36)
1.
Turn ON your set-top-box/satellite receiver.
2.
Aim the remote control at the front of your set-top-box/satellite receiver.
3.
Press and release the SET-TOP-BOX (STB) button to switch to set-top-box/satellite pre-coded mode.
4.
Hold down the STB button on the remote and enter the two digit preset code that matches your set-top-box/satellite receiver as
shown on page 36. The indicator light will flash 3 times if the code was accepted.
5.
Aim the remote at the set-top-box/satellite receiver and press the OFF button. The remote will turn off your set-top-box/satellite
receiver when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your set-top-
box/satellite receiver. If the set-top-box/satellite receiver does not turn off, try a different two digit preset code.
6.
The remote will now control your set-top-box/satellite receiver.
NOTES:
1.
If your set-top-box/satellite receiver cannot be operated
after performing the above procedures, your set-top-
box/satellite receiver code has not been precoded into the
remote.
2.
In the unlikely event that your set-top-box/satellite
receiver cannot be operated after performing the above
procedures, please consult your set-top-box/satellite
receiver operating guide.
3.
The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
4.
The ANT button will act as the TV/STB button when in
STB mode.
SET-TOP-BOX (STB) button
This button allows the remote to control your set-top-
box/satellite
receiver
BOX/SATELLITE mode.
PRECODED SET-TOP-BOX/SATELLITE RECEIVER buttons
These buttons transmit the chosen precoded satellite codes.
EXCLUSIVE TV buttons
These buttons are for operating the TV.
NOTE:
Refer to instruction manual of the Set-Top-Box/Satellite Receiver for operation of the buttons exclusively for the Set-Top-
Box/Satellite Receiver.
by
setting
it
to
SET-TOP-
SATELLITE CODE IS:
33
ON
OFF
VCR
CBL
TV
STB
SOURCE WIZARD
CD
TAPE
DVD
AMP
1
2
3
4
5
6
7
8
9
0
SLEEP
LAST CH
HELP
SELECT
VOL
CH
INFO
VID2
PIP
PIP CH
FREEZE
PIP ACCESS
SWAP
PIP MODE
TV/VCR
PROG
SLOW
REC
CLU-5715TSI
MY SET-TOP-BOX/
Advertisement
Table of Contents
