Mercedes-Benz G-Class Operator's Manual page 80

Seats
78
X
Push or pull the lower edge of the head
restraint in the direction of the arrow.
Resetting the front seat head restraints
It is necessary to reset the front seat head
restraints after the voltage supply has been
interrupted, e.g. if the battery has been
completely discharged or disconnected.
X
Make sure that the cup holder on the center
console is folded down (
X
Move the seat as far forward as possible
and the head restraint in as far as possible.
Rear seat head restraints
Important safety notes
G
WARNING
For safety reasons, always drive with the rear
head restraints in the upright position when
the rear seats are occupied.
Keep the area around head restraints clear of
articles (e.g. clothing) to not obstruct the
folding operation of the head restraints.
G
WARNING
For your protection, drive only with properly
positioned head restraints.
Adjust the head restraint in such a way that it
is as close to the head as possible and the
center of the head restraint supports the back
of the head at eye level. This will reduce the
potential for injury to the head and neck in the
event of an accident or similar situation.
With a rear seat occupied, make sure to move
the respective head restraint up from the
lowest non-use position and have the
occupant adjust the head restraint properly.
Do not drive the vehicle without the seat head
restraints installed when the rear seats are
occupied. Head restraints are intended to
help reduce injuries during an accident.
G
WARNING
Make sure the rear seat head restraints
engage when placing them upright manually.
Y page 193).
Otherwise their protective function cannot be
ensured.
The back of the head will not be supported in
the event of a collision. That could cause
serious or even fatal injuries. Rear seat
occupants can be seriously injured or killed.
Adjusting the rear seat head restraint
height
X
If the head restraint is fully lowered, it is
necessary to press release catch :.
X
To raise: pull the head restraint up to the
desired position.
X
To lower: press release catch : and push
the head restraint down until it is in the
desired position.
Adjusting the rear seat head restraint
angle
The angle of the rear head restraints is
adjusted in the same way as for the front head
Y
restraints ( page 77).
Installing/removing the rear seat head
restraints
X
To remove: pull the head restraint up to
the stop.
X
Press release catch : and pull the head
restraint out of the guides.
X
To re-install: place the head restraint in
the guides of the backrest.