Power Device
NOTE: Power on your TV . The initial startup of the Extender could
take up to one (1) minute .
Power on the Media Center Extender
DMA2200
Plug the Media Center Extender's power
cord connector to the unit's power port
on the back panel . Plug the cord into an
electrical outlet .
There is also an on/off power switch just
above the power port . Power on the unit
before starting Device Configuration .
DMA2100
This unit ships with the correct power
clips for your region . If needed, pull
out the clip covering the power port
connector . You can then snap in the
appropriate power clip that matches
your Main power outlet
Plug the Media Center Extender's power
cord connector to the unit's power port
on the back panel . Plug the cord into an
electrical outlet .
NOTE: There is an IR sensor on the front of the Media Center
Extender . Make sure the front panel is visible for the remote
control .
DMA2100
DMA2100
Power Cord Connection
Power Cord Connection
DMA 2100 Power Clips
DMA 2100 Power Clips
Device Installation
DMA2200
DMA2200
1