Regulatory Information; Safety Warning Statement; Fcc Rf Exposure Statement; Canadian Rf Exposure Statement - Cisco LINKSYS DMP100 User Manual

Wireless Home Audio

Regulatory Information

Safety Warning Statement

WARNING:
This
indicates that
warning of potential risk of bodily injury
and/or it is something that could damage your
property or product.
WARNING: Do not use this product near water,
for example, near a bath tub, kitchen sink, in a
wet basement or near a swimming pool.

FCC RF Exposure Statement

This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with
minimum distance of 20 cm between the radiator and
your body. This transmitter must not be co-located or
operating in conjunction with any other antenna.

Canadian RF Exposure Statement

This equipment is in conformity with the IC radiation
exposure limits set forth for an uncontrolled environment.
This device must be installed and used at a distance of at
least 20 cm (8 in) between the antenna and the body of
the user. The transmitter should not be placed close to
another antenna or another transmitter, or to function
with another antenna or another transmitter.
Avis d'Industrie Canada concernant
l'exposition aux radiofréquences
Cet appareil numérique est conforme aux limites établies
par IC en matière d'exposition aux radiofréquences dans
un environnement non contrôlé. Ce matériel doit être
installé et utilisé à une distance d'au moins 20 cm (8 in)
entre l'antenne et le corps de l'utilisateur. L'émetteur ne
doit pas être placé près d'une autre antenne ou d'un autre
émetteur, ou fonctionner avec une autre antenne ou un
autre émetteur.

Australian RF Exposure Statement

WARNING:
To ensure compliance with exposure
limits to radiofrequency fields, the antenna of
the device should be no closer than 20 cm from
the body during use.
Player/Wireless-N Music Extender
exclamation point
there is a caution

Approved Antenna Information

DMP100 player with Dipole type antenna and maximum
antenna gain of 3.5dBi in 5 GHz band and 1.5dBi in 2.4GHz
band.

FCC Part15 Class B Statement

or
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
This product has been tested and complies with the
specifications for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not
installed and used according to the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which is found by turning the equipment off and on, the
user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment or
•
devices
Connect the equipment to an outlet other than the
•
receiver's
Consult a dealer or an experienced radio/TV technician
•
for assistance

FCC Caution

Any changes or modifications not expressly approved by
the party responsible for compliance could void the user's
authority to operate this equipment.
For operation within 5.150-5.250 GHz frequency range, it
is restricted to indoor environment.
The availability of some specific and/or operational
frequency bands are country dependent and are firmware
programmed at the factory to match the intended
destination. The firmware setting is not accessible by the
end user.

IC Class B Statement (Canada)

This class B digital device complies with Industry Canada
ICES-003 and RSS-210 rules.
Operation is subject to the following two conditions:
1. This device may not cause interference and
Regulatory Information
44