Product Overview - Player - Cisco LINKSYS DMP100 User Manual

Wireless Home Audio

Product Overview - Player

Before You Begin
This User Guide is intended to provide details on use
of the product hardware and the user interface. For
initial installation instructions, please refer to the Quick
Installation Guide included with your product.
Features
Tos-Link, S/PDIF, RCA and 3.5mm Audio Outputs
•
Draft-N Wireless with Internal Antennas
•
Audio Formats: May be streamed in PCM or MP3,
•
Uncompressed formats:
formats: (MP3, AAC, MP2, WMA)
DLNA 1.5 and UPnP compliant and certified
•
Controlled by either the IR Remote (DMRIR500) or
•
the Controller – Wireless-N Touchscreen Remote
(DMWR1000)
Player/Wireless-N Music Extender
(WAV, PCM), Compressed
Product Overview - Player
Front Panel
Power (Blue/Orange) Pressing the Power
button toggles between Power on and
standby mode. Standby mode minimizes the
power consumed by your Player when not in
use. Standby mode allows you to power on
your unit using the remote control or power
button on the front panel.
To completely power off your Player,
disconnect the power from the device.
The LED light flashes blue while the device
is powering up and connecting to the
network. It will remain solid blue once the
device is connected to the network. When
the device is in standby mode, the LED will
appear orange. If the LED is red, there is an
issue with the device.
NOTE:
for 15 seconds will restore the
factory default settings.
WARNING:
default settings may revert to an
older version of the firmware. After
restoring the defaults, the firmware
can be manually updated or it
will be automatically updated if
autoupdates is selected.
Holding the Power button
Restoring factory
5