Management; Front Panel; Back Panel - Cisco Linksys DPC3008 User Manual

Linksys DPC3008/EPC3008

Management

• Software upgradeable by network download
•
Remote manageability using SNMP V1/V2 and V3

Front panel

The front panel of your modem provides LED status indicators that indicate
how well and at what state your modem is operating . See "Understanding the
Front Panel Indicators" on page 14 for more information .
1. POWeR—ON, power is applied to the modem .
2. DS—ON, the modem is receiving data from the cable network .
3. US—ON, the modem is sending data to the cable network .
4. ONLINe—ON, the modem is registered on the network and fully
operational .
5. LINK—ON, the Ethernet connection is operational . BLINKING indicates
that data is being transferred over the Ethernet connection . OFF indicates
that the Ethernet connection is not connected or has been disabled by
the user .
NOTe
After the modem is successfully registered on the network, the
POWER, DS, US, and ONLINE LEDs stay on continuously to indicate
that the modem is active and fully operational .

Back panel

DPC3008
EPC3008
1. ON/OFF SWITCH (Provided only on products that carry the CE mark)—
Allows you to turn off of the modem without removing the power cord .
Turning the modem off using this switch makes sure that the modem is
consuming no energy .
2. POWeR—Connects the modem to the provided AC power adapter . Use
only the power supply provided with your modem .
3. eTHeRNeT—One RJ-45 Ethernet port connects to the Ethernet port on
your computer or network .
4. ReSeT—Press and hold this switch for 2 seconds to restore settings to
factory defaults and reboot the modem .
CAUTION
The RESET button is for maintenance purposes only . Do not use
unless instructed to do so by your service provider . Doing so may
cause you to lose any settings you have selected .
5. MAC ADDReSS LABeL—Displays the MAC address of the modem .
6. CABLe—F-connector connects to an active cable signal from your
service provider .
Product Overview
9