Using The Remote To Control Vcr Functions; Precoded Vcr Buttons; Exclusive Tv Buttons - Hitachi 46F500 Operating Manual

Hitachi operating guide projection color tv 46f500, 51g500, 51f500, 57g500, 57f500

Training (154 pages)

Table of Contents

Operating the precoded function for your VCR.

This remote is designed to operate different types of VCRs. You must first program the remote to match the remote system of your VCR.

(refer to page 31 for pre-codes)

Turn ON your VCR.

Aim the remote control at the front of your VCR.

Press and release the DVD/VCR button to switch to VCR pre-coded mode.

Hold down the DVD/VCR button on the remote and enter the two digit preset code that matches your VCR, as shown on page 31.

Aim the remote at the VCR and press the POWER button. The remote will turn off your VCR when the correct two digit preset code

is entered. When this occurs, the remote control is programmed for your VCR. If the VCR does not turn off, try a different two digit

preset code.

The remote will now control your VCR.

NOTES:

If your VCR cannot be operated after performing the

above procedures, your VCR's code has not been

precoded into the remote.

In the unlikely event that your VCR cannot be operated

after performing the above procedures, please consult

your VCR operating guide.

The remote control will remember the codes you have

programmed until the batteries are removed from the

remote control. After replacing the batteries repeat the

entire programming procedure as stated above.

DVD/VCR Button

This button allows the remote to control your VCR by setting

it to VCR mode.

PRECODED VCR Buttons

These buttons transmit the chosen precoded VCR codes.

For some VCRs, you must press the RECORD button twice

to record a program.

EXCLUSIVE TV Buttons

These buttons are for operating the TV.

NOTE:

Refer to instruction manual of the VCR for operation of the buttons exclusively for the VCR.