Table of Contents
Advertisement
2.
Use the provided Phillips head screws to fasten the brackets to the sides of the
RPS.
3.
Tighten the screws with a No. 1 Phillips screwdriver to secure each bracket.
4.
Align the bracket and rack holes. Use two pan-head screws with nylon washers to
fasten each bracket to the rack.
5.
Tighten the screws with a No. 2 Phillips screwdriver to secure the switch in the rack.
6.
Tighten the screws with a No. 2 Phillips screwdriver to secure the switch in the wall.
Check the Installation
Perform the following checks Before you apply power:
1.
Inspect the equipment thoroughly.
2.
Verify that all cables are installed correctly.
3.
Check cable routing to ensure that cables are not damaged and do not create a safety
hazard.
4.
Be sure that all equipment is mounted properly and securely.
NETGEAR Managed Switch
Hardware Installation
11
Mounting
bracket
Advertisement
Table of Contents
