NETGEAR AXM761 - ProSafe 10 Gigabit Installation Manual

AXM761_IG_10July09.fm Page 1 Friday, July 10, 2009 2:36 PM
ProSafe 10 Gigabit Ethernet SFP+ Module AXM761 e
Install Your Optical Module
The 10 Gigabit small form-factor pluggable (SFP+) module provides a full-duplex 10G bps
each direction for Ethernet operation on NETGEAR managed switches.
The switch will automatically detect the AXM761, so you can simply plug it into an
available module slot.
The module can be inserted or removed while the switch is operational.
AXM761
Installing a AXM761 Module
Insert the module firmly into the slot that supports the SFP+ interface. Make sure the optical
cable you use is multi mode LC to LC duplex cable.
AXM761
Removing a AXM761 Module
Release the module latch by pulling down the handle bar across the module, and pull the
module out of the module slot.
Technical Specifications
Standards IEEE 802.3ae 10GBase-SR
Wavelength 850nm
Dimensions (HxWxD) 0.46" x 0.53" x 2.19"
(11.9 mm x 13.7 mm x 55.7 mm)
Weight 17.1g
Operating Temperature 32 -158º F (0 - 70ºC)
Storage Temperature 32 -185 ºF (0 - 85ºC)
Operative relative humidity 85% @ (25ºC)
Operating Distance 2 - 300 m for 50/125 um MMF
2 - 33 m for 62.5/125 um MMF
Connectors LC
Power Consumption <1.0w
MTBF 4,986,536 hr (569 years)
Safety Certification UL 1950 CSA 22.2 No. 950
Environmental Compliance -RoHS